Thursday, 15 May 2014

Printing Problems

During printing, I experienced a few problems along the way. As it was my first time printing on these enlargers, I did not think to check the whole machine to see if it was all in working order. My print below show the problem I had when I started to print full size. They show a faded streak down the right side of the image. After printing the same negative a few times, changing the aperture and length of time exposed to see if the fadedness would go away, nothing changed. After checking with a few different people what could be the problem, it turned out it was a problem with the light bulb in the enlarger and that it needed tightening to make the light stronger.
Another problem I faced was using filters. After not using them for a while, I was a bit unsure on what filter to use when printing some of my negatives. My first attempt was the print below. On this one I used filter 5 which brought out a lot of detail that I wanted in the photograph, but it was way too white and the sky had totally disappeared. The only other problem when printing I had was placing the negatives in the negative carrier correctly as at the beginning of my printing I could not tell which way was the correct way for them below, shown in the print as it was not vertically correct.

Overall I feel like I have learned more and how to print more successfully by experiencing the problems above.  

No comments:

Post a Comment